Difference between revisions of "Shoulder Surface"

From Engineering_Policy_Guide
Jump to navigation Jump to search
m (remove "Key Points" box from the article)
m (Article moved to EPG Other Aspects of Pavement Design. (This 2008 article had 3346 hits. Hist: 2/23/09, Added A3 shldr guidance & updated use of A1, A2 & A3))
 
(One intermediate revision by one other user not shown)
Line 1: Line 1:
[[image:Shoulder Surface Photo.jpg|right|300 px]]
+
{|style="padding: 0.3em; margin-left:15px; border:2px solid #a9a9a9; text-align:center; font-size: 95%; background:#f5f5f5" width="240px" align="center"
Paved shoulders and aggregate stabilized shoulders provide a secure surface to accomodate vehicles for emergencies and other uses. Paved shoulders are an integral part of the pavement structure and are considered as part of the pavement design configuration. See [[231.4 Shoulder Width|Shoulder Width]] for additional information
+
|-
 
+
|'''This article has moved'''
On major roads the entire shoulder width should be paved. On minor roads the shoulder should be aggregate stabilized except where maintenance or safety concerns (e.g., edge drop off, high runoff road occurence) justify a paved shoulder. Shoulders on urban roadways with access control (major or minor) are to be paved. In no case will a paved or aggregate surface be used directly behind a mountable curb along the outer edge of a roadway. A curb and gutter will only be used with an anticipated posted speed less than 50 mph.
+
|-
 
+
|Shoulder Surface has moved to [[Other Aspects of Pavement Design#Shoulder Surface|Shoulder Surface]]. The content was not changed, only article's location.
Where a paved shoulder is provided for either concrete or asphalt pavements, the full thickness of the travel way pavement is extended laterally to a longitudinal joint 2 ft. outside the travel way. The remainder of the shoulder width is paved with 5 ¾ in. of concrete or asphalt, at the contractor's option, as a Type A2 Shoulder. Where an additional lane is considered imminent, a full depth Type A paved shoulder is provided as an integral part of the pavement structure, with the width desired for future lane use. In this case the joint is placed at the edge of the travel way.  Ramp shoulders should be consistent with the mainline. For ramps with integral curbs, the shoulder material and thickness will be specified in the pavement thickness determination.
+
|}
 
 
For maintenance, structural or safety concerns on a minor road, the pavement structure width may be extended two additional feet. If paving the remaining width of shoulder is justified, the shoulder should consist of the Type A2 shoulder design.
 
  
 
[[Category:450 Bituminous Pavement Design]]
 
[[Category:450 Bituminous Pavement Design]]
 
[[Category:550 Portland Cement Concrete Pavement Design]]
 
[[Category:550 Portland Cement Concrete Pavement Design]]
 
[[Category:350 Design for Bases and Aggregate Surfaces]]
 
[[Category:350 Design for Bases and Aggregate Surfaces]]

Latest revision as of 08:54, 27 August 2010

This article has moved
Shoulder Surface has moved to Shoulder Surface. The content was not changed, only article's location.