Difference between revisions of "Category:1003 Aggregate for Seal Coats"
Jump to navigation
Jump to search
| Line 29: | Line 29: | ||
All plant records shown in [[:Category:1001 General Requirements for Material#1001.2.5 Records and Reports|1001.2.5 Records and Reports]] shall be maintained. The aggregates shall be reported through SiteManager in accordance with [[Automation Section AS-3510]]. | All plant records shown in [[:Category:1001 General Requirements for Material#1001.2.5 Records and Reports|1001.2.5 Records and Reports]] shall be maintained. The aggregates shall be reported through SiteManager in accordance with [[Automation Section AS-3510]]. | ||
| − | |||
Revision as of 09:04, 13 July 2007
This article establishes procedures for inspecting and accepting aggregates for use in seal coats.
1003.1 Procedure
Inspection, testing and sampling will be governed by the instructions contained in 1001 General Requirements for Material.
Required field tests required are:
| TEST | Template | Template Description |
|---|---|---|
| Sieve Analysis | T27 | Sieve Analysis of Fine and Coarse Aggregate |
| Percent Deleterious | SAA001Bx* | NEWEST Deleterious 1003 Aggregate |
| *Test Template numbers have been depicted with a generic ‘x’ as some templates are updated and the last letter in the template name may change. The most current template for a template sequence should contain ‘NEWEST’ at the beginning of the template name. | ||
Samples required for Laboratory tests are:
- (a) Initial approval.
- (b) Production samples at the discretion of the district.
1003.2 Acceptance
Acceptance is based on routine tests in the field to ensure compliance Sec 1003.
1003.3 Records and Reports
All plant records shown in 1001.2.5 Records and Reports shall be maintained. The aggregates shall be reported through SiteManager in accordance with Automation Section AS-3510.
