Difference between revisions of "771.20 Cut and Spray Brush and Vines"
m (771.19 Cut and Spray Brush and Vines moved to 771.20 Cut and Spray Brush and Vines: re-numbered, per BR and MT) |
m |
||
| (One intermediate revision by the same user not shown) | |||
| Line 34: | Line 34: | ||
|} | |} | ||
| − | [[Category:771 Bridge | + | [[Category:771 Bridge Preventive Maintenance Guidelines|771.20]] |
Latest revision as of 08:50, 22 November 2016
| Code: R414 or R415 |
Brush and vines are controlled to provide clear zone for high water and airflow. This also provides safe access for repairs and visual inspections.
Brush cutting may be performed at anytime when labor and workload allow. Winter months are preferred due to lack of foliage and active growth. Brush and vine spraying is accordance with Herbicides and Roadsides.
Procedures
1. Cut brush as close to ground level as safely possible.
2. Do not leave sharp pointed stumps.
3. Spray or treat all cut stumps.
4. Brush needs to be removed and disposed of properly.
5. Consult EPG 821 Herbicides and Roadsides for proper application to control brush and vines.
Safety Concerns
When trees are close to power lines, removal should be performed by the utility company or by bonded specialty contractors. Follow proper handling procedures for all herbicides.
Photographs
| Brush under and around structures restrict water and air flow. The restriction of stream flow in flood conditions may redirect the flow and erode structural support areas. | 
|
 |
|
| The trimmed brush and trees should be cut close to the ground and the trunk not cut so it has a sharpened point. The stump should be treated with an herbicide to prevent regrowth after cutting. | 
|
| A clear area under and around the structure is the desired result. | |
 |
|
