Difference between revisions of "1055.4 Laboratory Testing Guidelines for Sec 1055"
m (Per CM, removed archaic SiteManager info and replaced with AASHTOWARE info) |
m (→1055.4.2 Sample Report: Per CM, replaced archaic "Automation Section" with AWP MA Sample Record, General) |
||
| Line 16: | Line 16: | ||
===1055.4.2 Sample Report=== | ===1055.4.2 Sample Report=== | ||
| − | The sample record shall be completed in AWP, as described in [ | + | The sample record shall be completed in AWP, as described in [https://epg.modot.org/forms/CM/AWP_MA_Sample_Record_General.docx AWP MA Sample Record, General], and shall indicate acceptance, qualified acceptance, or rejection. Appropriate remarks, as described in [[:category: 106 Control of Material#Reporting Test Results|Reporting Test Results]], are to be included in the remarks to clarify conditions of acceptance or rejection. Test results shall be reported on the appropriate templates under the Tests tab. |
[[Category:1055 Concrete Curing Material]] | [[Category:1055 Concrete Curing Material]] | ||
Latest revision as of 08:58, 24 November 2021
This article establishes procedures for Laboratory testing, approving and reporting Type l-D and Type 2 Class A liquid membrane-forming compounds, waterproof paper and white polyethylene sheeting suitable for curing portland cement concrete. Refer to Sec 1055 for MoDOT’s specifications.
1055.4.1 Procedure
Preliminary Laboratory approval for Type l-D or Type 2 Class A liquid membrane-forming compounds is based on the following procedure:
- (a) Manufacturer shall furnish a one-quart (one liter) sample. Laboratory tests on this sample shall be as set forth in ASTM C 309.
- (b) Manufacturer shall furnish certification and guarantee for a Type 2 Class A white pigmented curing compound as required in Sec 1055.2.1.
- (c) Upon completion of Laboratory tests and receipt of satisfactory manufacturer's certification, the supplier will be notified by letter whether the material is approved for use. Each approved brand and the manufacturer will be added to Concrete Curing Material Pre-Acceptance List.
Samples from each lot of Type l-D - clear or transparent, or Type 2 Class A - white pigmented, materials destined for MoDOT projects shall be tested according to methods set forth in ASTM C 309. Reflectance tests shall be determined by the manufacturer in accordance with ASTM C 309 and furnished to the Department in compliance with Sec 1055.2.1.
Original test data and calculations on liquid membrane-forming compounds shall be recorded in Laboratory workbooks. Test results shall be recorded through AASHTOWARE Project (AWP) for the appropriate type.
Waterproof paper shall be tested for Moisture Loss and Tensile Strength in accordance with the methods set forth in ASTM C 171.
White polyethylene sheeting for curing portland cement concrete shall be tested for moisture loss, thickness, tensile strength, and elongation in accordance with the methods set forth in ASTM C 171 or PS 17-69 as applicable.
1055.4.2 Sample Report
The sample record shall be completed in AWP, as described in AWP MA Sample Record, General, and shall indicate acceptance, qualified acceptance, or rejection. Appropriate remarks, as described in Reporting Test Results, are to be included in the remarks to clarify conditions of acceptance or rejection. Test results shall be reported on the appropriate templates under the Tests tab.
