Category:1003 Aggregate for Seal Coats

From Engineering_Policy_Guide
Revision as of 10:54, 12 July 2007 by Tschid (talk | contribs)
Jump to navigation Jump to search

This article establishes procedures for inspecting and accepting aggregates for use in seal coats.

1003.1 Procedure

Inspection, testing and sampling will be governed by the instructions contained in 1001 General Requirements for Material.

Required field tests required are:

Required Field Tests
TEST Template Template Description
Sieve Analysis T27 Sieve Analysis of Fine and Coarse Aggregate
Percent Deleterious SAA001Bx* NEWEST Deleterious 1003 Aggregate
*Test Template numbers have been depicted with a generic ‘x’ as some templates are updated and the last letter in the template name may change. The most current template for a template sequence should contain ‘NEWEST’ at the beginning of the template name.

Samples required for Laboratory tests are:

(a) Initial approval.
(b) Production samples at the discretion of the district.

1003.2 Acceptance

Acceptance is based on routine tests in the field to ensure compliance Sec 1003.

1003.3 Records and Reports

All plant records shown in 1001.2.5 Records and Reports shall be maintained. The aggregates shall be reported through SiteManager in accordance with Automation Section AS-3510.