User:Hoskir/Revision Request 4303
COPY ALL - 751.5.9.2.1.2 Bend Shapes
751.5.9.2.1.2 Bend Shapes
Types:
There are two types of bend shapes: standard pin bend shapes and stirrup pin bend shapes.
Standard pin bend shapes are bent around standard pins and have a finished bend diameter in accordance with that specified on the bridge plans. Standard 90° and 180° hooks (used in development of bars) are bent around standard pins in accordance with the hook dimensions specified on the bridge plans.
Stirrup pin bend shapes are bent around stirrup pins and have a finished bend diameter in accordance with that specified on the bridge plans. Stirrup 90°, 135° and 180° hooks are bent around stirrup pins in accordance with the hook dimensions specified on the bridge plans. The stirrup 180° hooks of Shape 37S may be used instead of the standard 180° hooks when lapping the stirrup bars for shallow structures.
Shape Number:
Standard bend shapes are shown with the Bill of Reinforcing Steel on every set of bridge plans. The letter “S” indicates the shape is a stirrup pin bend shape, otherwise the shape is a standard pin bend shape. Many of the legs of the standard shapes may be omitted as needed to create the required shape. (See Bar Shapes reference sheet.)
Shape numbers shown both with and without the S may have either stirrup bends or standard bends. Shape numbers shown only without the S must be made with standard bends. Shape numbers shown only with the S must be made with stirrup bends.
Non-standard shapes may be used when an unusual shape is required, and the shape can’t be obtained from one of the standard shapes. Shapes 50 (or 50S) through 55 (or 55S) are reserved for non-standard shapes. Calculate the total length of the bar and include it in the Bill of Reinforcing steel as Dimension B. On the bridge plans, show a detail of the shape, including all dimensions.
Fabrication:
Shapes are fabricated in accordance with the latest version of the CRSI Manual of Standard Practice, except fabricators shall use the finished bend diameters and hook dimensions specified on bridge plans. MoDOT deviates from CRSI as follows:
- Use ACI’s finished bend diameter for #4 and #5 stirrup pin bend shapes (4d instead of CRSI’s 5d).
- Dimension A or G is rounded up to next quarter-inch increment. (CRSI rounds to nearest inch increment for standard pin bend shapes and to nearest quarter-inch increment for stirrup pin bend shapes. CRSI’s rounding does not always provide the bar length needed for minimum extension of the hook).
- Dimensions H and J are rounded to the nearest eighth-inch increment (instead of nearest quarter-inch increment).
- Bar sizes 7 and 8 are not used in stirrup pin bend shapes.