Difference between revisions of "903.23 Laboratory Testing Guidelines for Sec 903"
m (→903.24.1.4 Aluminum Welding: Per BR and CM, E 903.24.1.4.1 and E 903.24.1.4.2 were deleted to removed archaic welder qualification info.) |
m (Smithk moved page 903.24 Laboratory Testing Guidelines for Sec 903 to 903.23 Laboratory Testing Guidelines for Sec 903: This article and subsequent EPG 903 articles (EPG 903.15 - EPG 903.24) were renumbered (became EPG 903.14 - 903.23) when TS deleted EPG 903.14 Emergency Management Signing)) |
(No difference)
| |
Revision as of 09:55, 27 April 2021
This article establishes procedures for Laboratory testing and reporting samples of material used for installation of highway signing including nuts, bolts, washers, polyurethane foam and specimens for welder qualifications.
Contents
903.24.1 Procedure
903.24.1.1 Bolts, Nuts and Washers
Chemical tests, consisting of mass of coating, shall be determined according to AASHTO M232. Chemical analysis of the base metal shall be determined, when requested, according to EPG 1020.8.1.1 Chemical Tests. Original test data and calculations shall be recorded in Laboratory workbooks. Test results shall then be recorded through SiteManager (SM).
Physical tests shall be conducted according to EPG 712.3.2.2 Physical Tests - Bolts and Nuts. Original test results and calculations shall be recorded through SM.
903.24.1.2 Polyurethane Foam
Tests on samples of polyurethane foam shall be conducted in accordance with the following methods:
- (a) Compressive Strength - ASTM D1621
- (b) Density - ASTM D1622
Original test results and calculations shall be recorded through SM.
903.24.1.3 Structural Steel Welding
Samples of structural steel welding shall be tested in accordance with EPG 712.3.2.3 Structural Steel Welding.
903.24.1.4 Aluminum Welding
Tests shall be performed in accordance with Section IX of the ASME Boiler and Pressure Vessel Code.
903.24.2 Sample Record
Test results for bolts, nuts, washers, and polyurethane foam shall be documented on the appropriate templates in SiteManager. The sample record is to indicate acceptance, qualified acceptance or rejection. Appropriate remarks, as described in EPG 106.20 Reporting, are to be included in the remarks to clarify conditions of acceptance or rejection.
Procedure qualification test results for welds shall be reported through SiteManager. Welder qualification test results are also reported through SiteManager.
Current welder qualification status is maintained in SiteManager by Bridge Engineering.
